The Daikin DRG Commercial Gas Packaged Air Conditioner are designed with fast and easy installation in mind and are ideal for both new construction and retrofit projects. Our packaged rooftop units are built to be a direct replacement for most rooftop units on the field without the need of a curb adapter, to be able to replace the unit in a shorter time and at a lower cost (compared to the previous design).
Standard Features:
Two-stage scroll compressor for partial load applications.
Resiliently factory-mounted on rubber grommets for vibration isolation
Unit is factory charged with environmentally friendly R-410A refrigerant.
Compressor location outside the condenser section to avoid air bypass.
Internal overload protection included with compressor.
Fan wheel is continuously welded to the hub plate and end rim for long-lasting reliable operation.
Direct-drive ECM motor removes the need for belts, sheaves, or bearings and its permanently lubricated motors provide low maintenance cost.
Each fan assembly is dynamically trim balanced at the factory before shipment for quick start-up and efficient operation.
Electromechanical integrated controls modulate the supply fan motor
Motor with thermal overload and phase failure protection is provided for motor long lasting operation.
Coils are factory pressure tested to ensure pressure and leak integrity.
Removable Drain pan for easy maintenance and cleaning.
3-phase unit meets the performance specified as of 1/1/2015 in Table 6.8.1-1 of ASHRAE Standard 90.1-2013
Cabinet Features:
Daikin packaged rooftop units are made with high quality galvanized steel with a powder-paint finish to provide higher corrosion resistance
The interior surface in the indoor air section is fully insulated to prevent sweating and thermal losses, using our foil face fiberglass insulation which also omits exposed filter fibers into the airstream.
1" Raised flanged edges around the supply and return offer easy installation for the duct connections.
The full perimeter base rail is built using heavy gauge galvanized steel for a stronger structural installation. The base rails are a minimum of 3 ½" tall and include holes to allow for overhead rigging and lifting with forklifts.
Electrical lines and gas lines can be brought through the base of the unit or through the horizontal knockout for easy installation and accessibility on the field.
**Due to the specialized nature of this equipment manufactured to specific job requirements (i.e. voltage, btu, etc.) returns will NOT be accepted on any Commercial Equipment sales. Please be sure to check your application specifications carefully prior to placing your order. ALL SALES ARE FINAL.**