IMPORTANT NOTE: When purchasing COOLING ONLY HVAC EQUIPMENT, Florida residents must refer to the new Florida Building Code, 8th Edition Section R501.7.2 which became effective on December 31st, 2023. This section can be viewed online here or you may review the letter provided by the Technical Director of the DBPR Florida Building Codes and Standards in the documents section below.
The Direct Comfort GSX14 Air Conditioner uses the chlorine-free refrigerant R-410A and features operating sound levels that are among the lowest in the heating and cooling industry. With its 14 SEER rating, the GSX14 will help reduce energy consumption throughout the life of the system.
Standard Features:
Energy-efficient compressor
Factory-installed filter drier
Copper tube/aluminum fin coil
Service valves with sweat connections and easy-access gauge ports
Contactor with lug connection
Ground lug connection
AHRI Certified
ETL Listed
Cabinet Features:
Direct Comfort louvered sound control top design
Steel louver coil guard
Heavy-gauge galvanized-steel cabinet
Attractive Architectural Gray powder-paint finish with 500-hour salt-spray approval
Top and side maintenance access
Single-panel access to controls with space provided for field installed accessories
When properly anchored, meets the 2010 Florida Building Code unit integrity requirements for hurricane-type winds Anchor bracket kits available
The Direct Comfort AWUF Air Handler (front-return) is designed to be vertically wall or stud mounted. This unit features a check flowrater and direct drive, multi-speed motor. The AWUF is housed in a fully insulated, galvanized-steel cabinet.
Standard Features:
Suitable for use with refrigerants R-410A (16 models only) and R-22 (16 & 1 models)
Check flowrater for cooling and heat pump applications
Direct-drive, multi-speed motor
Sequence-controlled, rust-resistant nickel chromium heating elements of 5, 8 and 10 kW
ARI Certified; ETL Listed
Thermoplastic drain pan with bottom primary/secondary drain connection
Built-in filter rack (filter included)
Factory-installed pull-type disconnect
Large Chassis (2 and 3 Ton Units); Front Return Only
Small Chassis (1 and 2 Ton Units); Front or Bottom Return