Toggle Nav
  • Order Online or Call
  • (888) 474 - 9966
  • Mon - Fri 9:00am - 3:00am EST - Se Habla Español
    Sat - Sun 9:00am - 6:00pm EST
My Cart
SHOPPING CART items 0 items

“Your Trusted Online HVAC Wholesaler for Over 15 Years”

Hard Start Capacitor for Condensers and Heat Pumps (3.5 Ton - 5 Ton)

Model:CSR-U-2
$71.95

In Stock

QTY: - +
  • Use Coupon Code ACC10 for 10% Off!
  • Free Shipping
  • 110% Price Match Guarantee
Hard Start Capacitor for Condensers and Heat Pumps (3.5 Ton - 5 Ton) is available to buy in increments of 1

Description

The CSR-U 5-2-1 Compressor Saver Hard Start Kit protects these components by significantly reducing the amount of time it takes for your compressor to start - in some cases up to 50%. This means your air conditioner and compressor will bear - the stress, strain and heat each and every time it starts. Considering that your air conditioner may start up more than 6,000 times in a single cooling season, the positive impact that the 5-2-1 Compressor Saver® has on your air conditioner is significant.

Starting up is the hardest time in the life of any type of electrical equipment. Ever notice that light bulbs almost always burn out when you first turn them on and not while they are on? This is due to the huge current that rushes in when a switch is thrown and power is first applied. Your air conditioner uses anywhere from 5 to 10 times more power on start-up than it does while running. With this burst of power comes a surge of heat that accompanies the electrical current. This heat damages the compressor, the termnals, the windings and run capacitor - all vital components of your air conditioner.

Before you replace your air conditioner, try adding a 5-2-1 Compressor Saver®. The 5-2-1 Compressor Saver® might save you from having to outlay thousands of dollars to buy a new air conditioner or compressor. At a fraction of the cost, installing the 5-2-1 Compressor Saver® is a wise investment.


Equipment that needs a hard-start capacitor:

  • Heat pumps or condensers split-systems that have a thermostatic expansion valve (TXV) installed on them
  • Old heat pump or condensers that are mechanically stuck and not operating


If you have a new or old compressor that isn't starting, try installing this hard-start capacitor before you do anything else. The parts inside a compressor might be too physically tight to move, or on systems with a TXV where the refrigerant pressures are higher on start-up, and need an extra surge of energy to get started. This hard-start capacitor provides that extra bit of energy. The capacitor is very easy to install (takes about 1 minute) and will remain permanently in the equipment.

Product Specification

Model Number(s) CSR-U-2
UPC # 640852917486

Customer Reviews

For More Reviews

Hard Start Capacitor for Condensers and Heat Pumps (3.5 Ton - 5 Ton)

Model:CSR-U-2

$71.95

QTY: