The Direct Comfort GSX14 Air Conditioner uses the chlorine-free refrigerant R-410A and features operating sound levels that are among the lowest in the heating and cooling industry. With its 14 SEER rating, the GSX14 will help reduce energy consumption throughout the life of the system.
Standard Features:
Energy-efficient compressor
Factory-installed filter drier
Copper tube/aluminum fin coil
Service valves with sweat connections and easy-access gauge ports
Contactor with lug connection
Ground lug connection
AHRI Certified
ETL Listed
Cabinet Features:
Direct Comfort louvered sound control top design
Steel louver coil guard
Heavy-gauge galvanized-steel cabinet
Attractive Architectural Gray powder-paint finish with 500-hour salt-spray approval
Top and side maintenance access
Single-panel access to controls with space provided for field installed accessories
When properly anchored, meets the 2010 Florida Building Code unit integrity requirements for hurricane-type winds Anchor bracket kits available
The Direct Comfort CAPF, CAUF, CHPF, CAPT and CSCF Evaporator Coils are designed for use with Direct Comfort Gas Furnaces, Split System Air Conditioners and Heat Pumps, as well as modular, two-piece blowers. Each cased coil has a quality, galvanized-steel cabinet.
Standard Features:
Suitable for use with R-410A and R-22 refrigerants
Rust-proof, thermoplastic drain pans feature a low water-retention design
Check flowrater expansion device for heat pump or cooling-only applications
Rifled aluminum tubing and louvered aluminum fin coils on CAPF, CAUF, and CSCF coils
Rifled aluminum tubing and louvered aluminum fin coils on the CHPF coil
Cabinet Features:
Foil-face insulation
Galvanized leather-grain finish
Architectural Gray paint finish on CAPF and CHPF cased coils
Split-seam front for easy access
The Direct Comfort GMH8/GDH8 Gas Furnaces feature a patented aluminized-steel tubular heat exchanger and durable Silicon Nitride Hot Surface Ignition system. These furnaces are run-tested for heating or combination heating/cooling applications. With a heavy-gauge, reinforced, insulated steel cabinet and durable baked enamel finish, these furnaces can be installed in a variety of locations.
Standard Features:
Dual-diameter tubular heat exchanger
Two-stage gas valve Dual$aver technology that allows installer to activate the two-stage valve with the flip of a dip-switch
110V Silicon Nitride igniter designed for long igniter life
Furnace control board with self-diagnostics, color-coded low-voltage terminals, and provisions for electronic air cleaner and 24-volt humidifiers
Control board stores the last five diagnostic codes in memory; simple push-button activation outputs the fault history to a flashing red LED
Low constant fan allows homeowner to activate the low heat speed to efficiently circulate air throughout the home.
Self-adjusting feature automatically adjusts furnace to high- or low-stage operation based on outside temperature without an outdoor temperature sensor
Cabinet Features:
Fully insulated, heavy-gauge steel cabinet with durable baked-enamel finish
Foil-faced insulation lines the heat exchanger
Factory-sealed to achieve 2% or less leakage rate at 1.0 water gauge external duct static pressure
Designed for multi-position installation: upflow, horizontal left or right
Removable bottom for side or bottom return applications
Convenient left or right connection for gas/electric service