The Direct Comfort GSX14 Air Conditioner uses the chlorine-free refrigerant R-410A and features operating sound levels that are among the lowest in the heating and cooling industry. With its 14 SEER rating, the GSX14 will help reduce energy consumption throughout the life of the system.

Standard Features:

• Energy-efficient compressor
• Factory-installed filter drier
• Copper tube/aluminum fin coil
• Service valves with sweat connections and easy-access gauge ports
• Contactor with lug connection
• Ground lug connection
• AHRI Certified
• ETL Listed

Cabinet Features:

• Direct Comfort louvered sound control top design
• Steel louver coil guard
• Heavy-gauge galvanized-steel cabinet
• Attractive Architectural Gray powder-paint finish with 500-hour salt-spray approval
• Top and side maintenance access
• Single-panel access to controls with space provided for field installed accessories
• When properly anchored, meets the 2010 Florida Building Code unit integrity requirements for hurricane-type winds Anchor bracket kits available

The Direct Comfort CAPF, CAUF, CHPF, CAPT and CSCF Evaporator Coils are designed for use with Direct Comfort Gas Furnaces, Split System Air Conditioners and Heat Pumps, as well as modular, two-piece blowers. Each cased coil has a quality, galvanized-steel cabinet.

Standard Features:

• Suitable for use with R-410A and R-22 refrigerants
• Rust-proof, thermoplastic drain pans feature a low water-retention design
• Check flowrater expansion device for heat pump or cooling-only applications
• Rifled aluminum tubing and louvered aluminum fin coils on CAPF, CAUF, and CSCF coils
• Rifled aluminum tubing and louvered aluminum fin coils on the CHPF coil

Cabinet Features:

• Foil-face insulation
• Galvanized leather-grain finish
• Architectural Gray paint finish on CAPF and CHPF cased coils
• Split-seam front for easy access

The Direct Comfort GMEC96 Gas Furnace with two-stage gas valve and a Multi-Speed ECM Motor provides efficient and economical performance. Unlike single-stage gas furnaces that operate all on or all off, a Direct Comfort two-stage gas furnace typically runs at the lowest possible speed to precisely maintain a constant, steady temperature in your home. A two-stage gas furnace optimizes its heating output to maximize indoor comfort and lower energy costs.

Standard Features:

• Energy-efficient, multi-speed ECM blower motor
• Heavy-duty, aluminized-steel tubular heat exchanger
• Stainless-steel secondary heat exchanger
• Two-stage gas valve provides quiet, economical heating
• Durable Silicon Nitride igniter
• Quiet two-speed induced draft blower
• Utilizes ComfortNet communicating, two-stage or single-stage thermostats
• Self-diagnostic control board with constant memory fault code history output to a LED
• Color-coded low-voltage terminals with provisions for electronic air cleaner and humidifier
• Low continuous fan speed options offer quiet air circulationAll models comply with California Low NOx emissions standards

Cabinet Features:

• Designed for multi-position installation upflow, horizontal left or right
• Certified for direct vent (2-pipe) or non-direct vent (1-pipe)
• asy-to-install top venting with optional side venting
• Convenient left or right connection for gas and electrical service
• Cabinet air leakage (Q Leak) ‰¤ 2%
• Heavy-gauge steel cabinet with durable finish
• Fully insulated heat exchanger and blower section
• Airtight solid bottom or side return with easy-cut tabs for effortless removal in bottom air-inlet applications