The York YHJF 15 SEER Series Heat Pump is the outdoor part of a versatile climate system. It is designed with a matching indoor coil component from Johnson Controls Unitary Products. Available for typical applications this climate system is supported with accessories and documents to serve specific functions.
Standard Features:
Quality Condenser Coils - The coil is constructed of copper tubing and enhanced aluminum fins for increased efficiency and corrosion protection.
Protected Compressor - The complete scroll compressor line is internally protected against high pressure, temperature, and externally by a factory installed high pressure switch. This is accomplished by the simultaneous operation of high pressure relief valve and a temperature sensor which protects the compressor if undesirable operating conditions occur. A liquid line filter-drier further protects the compressor.
Durable Finish - The cabinet is made of pre-painted steel. The pre-treated galvanized steel provides a better paint to steel bond, which resists corrosion and rust creep. Special primer formulas and matted-textured finish insure less fading when exposed to sunlight.
Lower Installed Cost - Installation time and costs are reduced by easy power and control wiring connections. Available in sweat connect models only. The unit contains enough refrigerant for matching indoor coils and 15 feet of interconnecting piping. The small base dimension means less space is required on the ground or roof.
Top Discharge - The warm air from the top mounted fan is blown up away from the structure and any landscaping. This allows compact location on multi-unit applications.
Swept Fan Blade Sound Jacket - The upward air flow carries the normal operating noise away from the living area. The rigid top panel effectively isolates any motor sound. Isolator mounted compressor and the rippled fins of the condenser coil muffle the normal fan motor and compressor operating sounds. The swept wing fan blade and compressor sound jacket futher reduce noise levels.
Low Maintenance - Long life permanently lubricated motorbearings need no annual servicing.
The York MV Modular Blower allows the flexibility to handle any application. These versatile blowers may be used for upflow, downflow, or horizontal left or right applications. They may be combined to function as a cooling only unit or with a heat pump including electric heat for 1 and 3 phase applications. The blower and electric heater could be used as stand alone electric furnaces.
Standard Features:
Models to match any air flow or voltage requirement.
The compact size allows easy installation.
Blowers are sized to deliver design air quantity both efficiently and quietly.
The motors provide a selection of air quantities to match any application.
All models include a one-minute blower off delay as standard to enhance system efficiency ratings.
The durable, pre-painted steel protects the unit against rust and corrosion.
All models have 1 inch foil face fiber glass insulation, providing a thermal insulation value of R-4.2. |
